This flagpole holder is designed to fit all Harley-Davidson FLT and FLH models. The two small receiver tubes bolt onto the lower fender, and or saddlebag supports and remain virtually unseen. The flagpole holder bar can then be installed or removed from the receiver tubes in seconds by removing two safety pins. Included is one flag holder socket. One or tow more can be added (sold separately below) to accommodate up to three flags. The sockets accommodate up to 1 ¼” poles and are maintained at a 15 degree angle to their bases. They can be rotated and tightened to display your flags, angled to the rear, sides, diagonally, or any combination of these. All components are machined from aircraft quality aluminum and steel and polished to a flawless finish and triple chrome plated.